Choose the right brake pads according to different driving environments

How to choose brake pads for vehicles that often drive in mountainous areas?

Here is mainly from the perspective of formula design analysis and recommendations. Vehicles that often drive in mountainous areas often drag the brakes (that is, drive with the brakes) due to the length of the slope and many other reasons. The brakes are caused by excessive friction. The sheet heats up very seriously, even for high-temperature parts, it is recommended to choose high-temperature products with a higher coefficient of friction. At the same time, it should be considered that the brake pads should not have cracked lines on the surface after friction.

How to choose a vehicle that often drives in coastal areas or wet areas?

This is mainly a suggestion given by formula design analysis. Vehicles often drive in coastal areas or humid places, and the air humidity is relatively high. If you choose brake pads with more metal, rust and corrosion are prone to occur. It is recommended to choose a low metal or a brake pad with ceramic organic fiber.

How to choose brake pads when vehicles are often driving in the northwest plateau area?

Here is mainly from the formulation design to analyze the recommendations given. In the northwest plateau, the air is relatively dry, so there is no special requirement for the use of brake pads. You can select some more cost-effective brake pads based on comprehensive capabilities and evaluation.

Why does the handbrake sometimes do not work well in winter

In the winter in the north, the cold wind is very cold, and the temperature is generally very low. When the temperature is below freezing, the handbrake may not work well. The reason for this may be the existence of the car brake pads and the counterpart. The friction coefficient of the brake pads is greatly reduced due to the ice layer or water layer. When this problem occurs, we only need to gently pull the handbrake when the vehicle is moving slightly to make the brake pads and the mating part rub for a few seconds. The ice layer or The water layer will be eliminated.